ISSPRO R7703 - Manual

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211
Telephone: (503) 288-4488 Š Toll Free: (800) 888-8065
FAX: (503) 249-2999
Form No. IS020 (8/10/01 Rev. A) Page 1 of 1
ISSPRO DUAL & TRIPLE GAUGE HOLDERS
(Full Pillar – All Models)
ASSEMBLY INSTRUCTIONS
Your carton should contain the Gauge Holder and a package containing six fasteners (“Christmas
tree pins”), along with these instructions. You will need a 3/16” drill to install your Gauge
Holder.
1. The Full Pillar Gauge Holder mounts over the existing stock A-pillar.
2.
Remove the stock A-pillar.
3.
While holding the Gauge Holder over the A-pillar in its finished location, drill 3-16”
holes through the four corners of the Gauge Holder and through the A-pillar. (Two
additional fasteners have been included to be used at the installer’s discretion.) Note:
some minor trimming of the Gauge Holder may be required in some applications for a
perfect fit.
4.
Install gauges by pressing them into the holes in the Gauge Holder.
5.
There is room for the gauge lines to run between the A-pillar and the Gauge Holder
and out the bottom without interference. If there is interference, make an opening in
the A-pillar for the lines to pass through. Fasten the gauge lines to the back of the
Gauge Holder or the A-pillar.
6.
Insert the “Christmas tree pins” through the drilled holes to secure the Gauge Holder
to the A-pillar.
7.
Feed the gauge lines through the firewall to the engine.
8.
First, re-install the A-pillar; then attach the gauge holder to the pillar, checking for
sufficient wiring length (2” of slack recommended). Take care not to pinch the gauge
lines in the process.
LIMITED WARRANTY
ISSPRO, Inc. warrants to the consumer that its gauge holder products will be free from defects in
materials or workmanship for 1 year following purchase by the end user. Warranty is limited to
replacement or credit at ISSPRO’s option, of defective parts within the warranty period. Parts
must be returned, prepaid, to the original purchase point for warranty inspection. This warranty
does not apply to misapplication, misuse, negligence or accident. This warranty is in lieu of any
other expressed or implied warranties, including any implied warranty of merchantability or
fitness for a particular purpose, and of any other obligation on the part of the seller. In no event
will the seller be liable for incidental or consequential damages.