9measurements, Measurement parameters, Units – JDC Electronic SA Skywatch Aero User Manual
Page 9: Date and time
GB
9
Measurements
Click on button to start the measurement process. Press on button to stop it. If the
station is deleting memory, it is not possible to start the measurement process.
When the measurement process is activated, the LED flashes for 3 seconds, then flashes
once every three seconds. When the measurement process is complete, the LED flashes
again for 3 seconds before going out.
Measurement parameters
The station takes a wind measurement every second. The duration in seconds on which
the average is to be calculated has to be defined. This interval can be changed by entering
the desired value to the field set up for this. When the new average is indicated to you,
press on “Update” to transmit the information to the station. The other parameters
(temperature, humidity, pressure) are measured once per interval.
Units
The user can choose in which unit the measured values should be displayed. The units
selected are used for real-time display and for saving the measurements in the CSV file.
These units are saved in memory.
Date and Time
The software displays the station time. To update this time in relation to the PC, press
on “Update” button.
Please note that the changing non DST / DST is not automatically done by the station.