High beam switch, Flash-to-pass, Headlight time delay – Jeep 2009 Grand Cherokee - Owner Manual User Manual

Page 139: Interior lights

Advertising
background image

High Beam Switch

Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
towards you to switch the headlights back to low beam.

Flash-to-Pass

You can signal another vehicle by lightly pulling the
multifunction lever toward the steering wheel. This will
cause the high beam headlights to turn on, and remain on
until the lever is released.

Headlight Time Delay

This feature delays turning off the headlights for 30, 60,
or 90 seconds after the ignition switch is turned OFF. To
activate the headlight delay, the multifunction lever must
be rotated to the “Off” position after the ignition switch
is turned to LOCK/ACC. Only the headlights will illu-
minate during this time. Refer to “Electronic Vehicle
Information Center (EVIC) – Customer-Programmable
Features” in Section 4 to turn this feature “On/Off” or set
the time interval.

Interior Lights

The interior lighting consists of courtesy lights (below the
instrument panel), an overhead console light (which

High Beam/Low Beam Select

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

137

3

Advertising
This manual is related to the following products: