Enhanced seat belt use reminder system (beltalert) – Jeep 2009 Grand Cherokee - Owner Manual User Manual

Page 46

Advertising
background image

NOTE:

These devices are not a substitute for proper seat

belt placement by the occupant. The seat belt must still be
worn snugly and positioned properly.

The pretensioners are triggered by the Occupant Re-
straint Control (ORC). Like the front airbags, the preten-
sioners are a single use item. After a collision that is
severe enough to deploy the airbags and pretensioners,
they must be replaced.

Enhanced Seat Belt Use Reminder System
(BeltAlert

)

If the driver’s seat belt has not been buckled within
60 seconds of starting the vehicle and if the vehicle speed
is greater than 5 mph (8 km/h), the Enhanced Seat Belt
Use Reminder System (BeltAlert

௡) will alert the driver to

buckle the seat belt. The driver should also instruct all
other occupants to buckle their seat belts. Once the
warning is triggered, BeltAlert

௡ will continue to chime

and flash the Seat Belt Reminder Light for 96 seconds or

until the driver’s seat belt is buckled. BeltAlert

௡ will be

reactivated if the driver’s seat belt is unbuckled for more
than 10 seconds and the vehicle speed is greater than
5 mph (8 km/h).

BeltAlert

௡ can be enabled or disabled by your authorized

dealer or by following these steps:

NOTE:

The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON
or START position. Chrysler LLC does not recommend
deactivating BeltAlert

௡.

1. Turn the ignition switch to the OFF position, and
buckle the driver’s seat belt.

2. Turn the ignition key to the ACC/ON position (engine
does not need to be running), and wait for the Seat Belt
Reminder Light to turn off.

44

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Advertising
This manual is related to the following products: