Jeep 2014 Grand Cherokee SRT - User Guide - Manual (Page 20)

• You may use the LATCH anchorage
system until the combined weight of
the child and the child restraint is
65 lbs (29.5 kg). Use the seat belt and
tether anchor instead of the LATCH
system once the combined weight is
more than 65 lbs (29.5 kg).
• The lower anchorages are round
bars that are found at the rear of the
seat cushion where it meets the seat-
back, below the anchorage symbols on
the seatback. They are just visible
when you lean into the rear seat to install the child restraint. You will easily feel
them if you run your finger along the gap between the seatback and seat cushion.
• In addition, there are tether strap anchorages behind each rear seating
position located on the back of the seat. To access the top tether strap anchorages
behind the rear seat, pull the carpeted floor panel away from the seat back, this
will expose the top tether strap anchorages. DO NOT USE the cargo tie down loops
located on the load floor as tether anchorages.
WARNING!
Do not install a child restraint in the center position using the LATCH system. This
position is not approved for installing child seats using the LATCH attachments.
You must use the seat belt and tether anchor to install a child seat in the center
seating position.
GETTING STARTED
18