Electronics – Jeep 2015 Cherokee - User Guide User Manual
Page 82
Voice Texting — Want to dictate a personal message? Register with Uconnect
®
Access to take advantage of a new, cloudbased Voice Texting service, an enhance-
ment to Voice Text Reply.
Voice Texting allows you to compose a new text or reply to an incoming text message.
Before you attempt to use the Voice Texting feature, check to ensure you have the
following:
1. A paired, Bluetooth
®
enabled phone with the Message Access Profile (MAP). Not
all Bluetooth
®
enabled phones support MAP, including all iPhones
®
(Apple iOS).
Visit for system and device compatibility information.
2. An active Uconnect
®
Access trial or paid subscription. Press the “Apps” button
on the lower right hand corner of the touchscreen to begin the registration
process.
3. Accept the “Allow MAP” profile request on your smart phone. (Please refer to
device manufacturer instructions for details).
To Send A Text Message:
1. Push the Uconnect
®
Phone Button
on the steering wheel.
2. Wait for the beep.
3. Say “Text.”
4. Uconnect
®
will prompt you “Say the phone number, or full name and phone type
of the contact you want to send a message to.”
5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone
number that you would like to send the message to.
6. Uconnect
®
will prompt you “Please say the message that you would like to send.”
(If you do not hear this prompt, you may not have an active subscription with
Uconnect
®
Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you
exceed 140 characters, you will hear the following prompt: “Message was too
long; your message will be truncated.”
8. Uconnect
®
will then repeat the message back to you.
9. Uconnect
®
will prompt you: “To add to your message, say “Continue”; To delete
the current message and start over, say “Start Over”; to send the current message,
say “Send”; to hear the message again, say “Repeat”.
10. If you are happy with your message and would like to send it, wait for the beep
and say “Send”.
11. Uconnect
®
will then say “Sending your message.”
ELECTRONICS
80