Jeep 2015 Wrangler - Uconnect 730N Manual - Manual (Page 121)

VOICE COMMAND OPERATION
Voice Command allows you to control your AM and FM
radio, satellite radio, disc player, navigation system, hard
disk drive storage, AUX mode devices (digital music
players) and a memo recorder.
NOTE:
Take care to speak into the Voice Command system as
calmly and normally as possible. The ability of Voice
Command to recognize user voice commands may be
negatively affected by rapid speaking or a raised voice
level.
WARNING!
Only use these features when it is safe to do so and
obey applicable laws. Failure to do so may result in a
collision causing serious injury or death.
When you push the Voice Command button
on the faceplate, you will hear a beep. The beep
is your signal to give a command.
NOTE:
If you do not say a command within a few seconds, the
system will present you with a list of options.
If you ever wish to interrupt the system while it lists
options, push the Voice Command button on the
faceplate, listen for the beep, and say your command.
Pushing the Voice Command
button on the faceplate
while the system is speaking is known as “barging in.”
The system will be interrupted and you can add or
change commands. This will become helpful once you
start to learn the options.
110 VOICE COMMAND