Karcepts KFSB-AP-XX - Manual (Page 10)

3. Quick Adjustment Setup (continued...)
D.
Lastly, for proper quick adjust functionality, the endlinks must be set to achieve
maximum articulation when installed in the current #4 Hole setting.
To do so, first loosen the endlink lock nut (middle nut of endlink).
Now, rotate both the top and bottom of the endlink halves clockwise until they
bottom out on themselves and will not rotate any further clockwise.
Finally, tighten the endlink lock nut. Once secure, you can rotate the endlink by
hand and should observe a good amount of sweep back and forth on the link,
verifying a large range of articulation has been achieved.