Karcepts KSM03 - Manual (Page 15)

4. RUNNING THE CABLES
Run the cables underneath of the crossmember and into the engine bay. You
may be able to secure the cables with one of the cable mounting brackets
supplied with the RSX cables. If unable to utilize the RSX cable bracket, tie wrap
or affix cables properly such that they do not contact the header, exhaust, or
anything else which may cause damage to them. Once cables are run properly,
attach their ends to the transmission using the factory Honda mounting hardware.
5. FINAL CHECKS/SEALING
1. Before installing your center console or sealing the mount completely, you will
need to make certain you can shift through all gears smoothly and that you are
able to engage into reverse gear. Problems may arise with this if not enough
material was removed or there are any burs that exist on the left rear edge of
the cut-out. This is due to the side-to-side lever arm potentially being too close
to the edge of the cut-out. If adequate material is removed, there will be no
issues. If necessary, unbolt the shifter mount and make final adjustments to
your chassis with a dremel or grinder.
Left rear edge includes these areas