Koala Kare 901-KIT - Manual

Tools Required:
Phillips Head Screwdriver
1. Remove the tray from the high chair and
place it face down on a table.
2. Locate the glide that needs replacing and
using a Phillips Head Screwdriver remove the
three screws securing it to the tray.
3. Discard the old glide and screws.
4. Take the new glide and position it so that
three of the four holes align with the three
mounting hole in the tray. The red ball should
be facing the outside edge of the tray.
5. Use a Phillips Head Screwdriver to secure
the glide to the tray with the three screws
provided.
6. To ensure the new glide is functioning
correctly, test the spring by pulling outwards on
the red ball.
7. Clean the tray and return it to use.
KB104 CLASSIC HIGH CHAIR TRAY
REPLACEMENT GLIDE INSTRUCTIONS
P/N 901-KIT
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
P/N 1017 May 2012
Materials Supplied:
Three Phillips Head 8-16 x ½” Thread Rolling Screws
One Glide Hardware