Kontron CP-RIO6-001-HD-VGA - Manual (Page 26)

Functional Description CP-RIO6-001-HD-VGA
Page 2 - 4 ID 1052-4138, Rev. 1.0
2.1.1.2 Onboard USB NAND Flash Connector J14
The CP-RIO6-001-HD-VGA rear I/O module has one onboard USB interface implemented on a
9-pin connector, J14, with the following pinout.
The J14 connector is used to connect an optional USB 2.0 NAND Flash module qualified by
Kontron. The USB 2.0 NAND Flash module is a USB 2.0-based NAND Flash drive with a built-
in full hard-disk emulation and a high data transfer rate. It is optimized for embedded systems
providing high performance, reliability and security.
Note ...
Only qualified USB 2.0 NAND Flash modules from Kontron are authorized for
use with the CP-RIO6-001-HD-VGA. Use of unqualified USB 2.0 NAND Flash
modules or improper installation will void the warranty and may result in dam-
age to the CP-RIO6-001-HD-VGA or the system.
Figure 2-2: USB NAND Flash Con. J14
1
2 10
9
Table 2-2: USB NAND Flash Con. J14 Pinout
PIN SIGNAL FUNCTION I/O
1 VCC VCC --
3 UV0- Differential USB- I/O
5 UV0+ Differential USB+ I/O
7 GND GND --
9 Key
2, 4, 6, 8 NC Not connected --
10 Res. Reserved --