Installing the board, 1 onboard connectors and headers, 2 board hot swap and installation – Kontron AM4521 User Manual
Page 22: 1 installing an amc, Installing an amc, Table 3-1 onboard connectors & headers
11
www.kontron.com
3. Installing the Board
3.1
Onboard Connectors and Headers
Table 3-1:Onboard Connectors & Headers
3.2
Board Hot Swap and Installation
Some precautions must be taken when connecting or disconnecting a board:
1 Rail guides must be installed on the enclosure to slide the board to the backplane.
2 Do not force the board if there is mechanical resistance while inserting the board.
3 Use extractor handle to disconnect and extract the board from its enclosure.
3.2.1
Installing an AMC
To install an AMC:
1 Remove the AMC filler panel.
2 Carefully engage the AMC into the card guide. Push the AMC until it fully mate with it's connector. Secure
the AMC handle to the locking position.
3 In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It will turn OFF at the
end of the hot swap sequence.
Description
Connector
Comments
AMC Connector
J4
AMC Connector
SATA Connector
J5
Serial ATA Connector
WARNING
Always use a grounding wrist wrap before installing or removing the board from a
chassis.