Kontron AM4100 - Manual (Page 31)

AM4100 Introduction
ID 36126, Rev. 2.0 Page 1 - 13
P R E L I M I N A R Y
1.8 Related Publications
The following publications contain information relating to this product.
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.
Table 1-4: Related Publications
PRODUCT PUBLICATION
ATCA PICMG® 3.0 AdvancedTCA Base Specification R2.0, March 18, 2005
MicroTCA PICMG® MTCA.0 Micro Telecommunications Computing Architecture R1.0, July 6,
2006
AMC PICMG® AMC.0, Advanced Mezzanine Card Specification R2.0
PICMG® AMC.1, PCI Express and Advanced Switching R1.0
PICMG® AMC.2, Gigabit Ethernet R1.0
PICMG® AMC.4, Serial RapidIO Draft 0.4
IPMI IPMI - Intelligent Platform Management Interface Specification, v2.0 Document
Revision 1.0, February 12, 2004
IPMI - Platform Management FRU Information Storage Definition, V1.0 Document
Revision 1.1, September 27, 1999
PCI Express PCI Express Base Specification Revision 1.0a
Serial RapidIO RapidIO Interconnect Specification Revision 1.2