Kontron AM4150 U-Boot Bootloader - Manual (Page 29)

AM4150 U-Boot Bootloader U-Boot Usage
ID 1052-5678, Rev. 1.0 Page 29
P R E L I M I N A R Y
USAGE: Select new base configuration
COMMAND / RESPONSE:
=> sconf select 1
New base configuration 1
=>
Configure parameter for new base configuration
COMMAND / RESPONSE:
=> sconf set
Board’s Port Configuration:
Option / Setting | Value # command, option <and parameter>
-----------------------------------------------------------
DTSEC4 routing : port1 # sconf set dtsec4 <port1 | front>
SRIO Sys.Size : large # sconf set srio <small | large>
SRIO mode : agent # sconf set srio <agent | host >
AMC Port Activation / Forced settings (ignoring E-Keying):
Option / Setting | Value # command, option <and parameter>
-------------------------------------------------------------
Port 2 : auto # sconf set port 2 < auto | disable | enable>
Port 4 : auto # sconf set port 4 < auto | disable | enable>
speed : @5.0 # sconf set port 4 < @5.0 | @2.5 >
Port 8 : auto # sconf set port 8 < auto | disable | enable>
speed : @5.0 # sconf set port 8 < @5.0 | @2.5 >
Note: A port’s speed configuration becomes effective if the port is
enabled when running the module in unmanaged mode, or the port is
forcibly enabled (i.e. not set to ‘auto’) in managed mode.
=> sconf set port4 disable
=>
Display current “sconf” status
COMMAND / RESPONSE:
=> sconf status
Configuration (Activation) Status:
Module is running: managed (E-Keying)
sconf disables E-Keying: no
sconf deactivated by DIP SW: no
Configuration (stored) is active:
AMC Base Configuration: 0
=>
sconf (continued)