Kontron pITX-SP - Manual (Page 45)

KTD-S0003-C Page 41 JIDA32 Interface
p ITX-SP Software Guide
11.5 Hardware Monitor Part
The hardware monitor part contains in most cases several subsections.
Section Sensor Count
Temperature 2
Fan Not supported
Voltage Not supported
11.5.1 Temperature
The term On-Chip diode designates the chip temperature of the temperature sensor (with no dependence to
the CPU temperature).
Sensor Number Abs. Thermal Limit
On-Chip diode 0 0 to +80 0 C
CPU diode 1 0 to +90 0 C
11.6 Digital I/O Part
This part defines the availability of digital input/output lines.
Type Port Pin Count Position
Input or Output 0 8 Bit 0 - 7
Input/Output 1 - 7 Not supported
11.7 Watchdog Part
The watchdog can be programmed with discrete timeout values on boards with CPLD implementation or in
millisecond resolution with boards using a Super-I/O. In the discrete value scenario if there is no exact
match to the timeout value the next higher one is used (Example pITX-SP: programmed value = 12 se-
conds, activated value = 30 seconds).
Type Steps Timeout Values Result
CPLD 7
1, 5, 10, 30 seconds
1, 5, 10 minutes
RESET
NMI not supported