La-Z-Boy Power Recliner - Manual (Page 6)

Power Ease TM Back
Assembly Instructions:
Power Ease TM Back
Assembly Details:
- To reduce the risk of injur y.
• Do not operate the unit until the back(s) are installed and locked.
CAUTION: Do not plug the transformer(s) in until instructed.
Install the chair or motion sofa back(s)
1. Lay the back across the arms of the body. Lift the back at a slight angle and
align the brackets on the back with the brackets on the body (F IGURE 1).
2. Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is properly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F IGURE 2). Remove the back and repeat the steps above.
• If you are unable to install the back properly contact your La-Z-Boy ®
dealer for assistance.
3. Lock the brackets using a slotted screwdriver to push down the locking levers;
do this for each bracket (F IGURE 3). For proper operation the brackets must be
locked down.
4. Repeat the above steps to install the remaining back(s) on a motion sofa unit.
5. Return to the Power Ease TM Recliner or Motion Sofa Assembly Instructions to
finish assembly.
WARNING
The following Back Assembly Instructions are for chair or sofa backs having
upholstery cover attached to all sides of the back frame. Refer to the instructions
on the next page if your chair or sofa backs have a loose upholstery cover
with fastening tape.
F IGURE 3
Back
Bracket
Locking
Lever
Locked
Position
F IGURE 1
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
Body
Bracket
Back
Bracket
11 10
F IGURE 2