La-Z-Boy Power Storage Console after 12/31/2012 - Manual (Page 4)

Power Storage Console
Assembly Instructions
7 6
NOTICE:
Do not plug in until instructed.
The power console has one rear side mount bracket and one front side mount “U” bracket on the
right side (sitting), and two threaded studs on the left side (sitting), (F
IGURE 1).
1. Use a T-30 torx driver to loosen the threaded studs to approximately 1”; this measurement may
vary depending on the fabric and style (F IGURE 2).
2. To start, place the units to be attached next to each other, about 2” apart. Position the unit with the
threaded studs slightly behind the unit with the attachment brackets. Separate the fronts of the units
to be connected, about 6” apart. Slide the rear of the unit with the threaded studs toward the unit
with the attachment brackets, aligning the threaded studs to the rear bracket. Pull the unit with
the threaded studs forward to engage the rear bracket.
NOTICE:
To reduce the risk of product damage:
• Lift from the base rail. Do not lift from the upholstery or the bottom of the legrest.
3. Lift the front of the unit with the threaded stud approximately 3” off the ground, aligning it to the
unit with the attachment bracket. Gently lower the threaded stud into the front attachment bracket
(F
IGURE 3). Keep feet clear of the unit when lowering it into position.
Note: Due to variations in upholstery and style, the threaded stud length may need to be adjusted to
fit into the attachment brackets or control gaps between units. Loosen or tighten the threaded studs
to provide adequate clearance.
4. Continue connecting the modular units until all have been securely joined.
Power Storage Console
Assembly Instructions
Rear Side
Mount Bracket
F IGURE 1
F IGURE 2 F IGURE 3
Front Side Mount
“U” Bracket
Threaded
Stud
Threaded
Stud
Front Side Mount
“U” Bracket
– To reduce the risk of injury:
• The front of the unit must be raised to engage the front bracket. Please seek assistance
if you are unable to lift at least 57 pounds.
• Keep feet clear of the unit when lowering it into position.
WARNING
NOTICE:
To reduce the risk of product damage:
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
5. All modular units must be disconnected to safely move the modular group. To disconnect the units,
lift up the left side (sitting) modular unit (with threaded studs) approximately 3” to clear the front
attachment bracket, move the front of the unit over and return it to the floor. Slide the unit with the
threaded studs backward to disengage the rear bracket.