Lifesmart SIRS-01 - Manual (Page 10)

10
OPERATING INSTRUCTIONS
1 . Turn the heater on or off by pressing the Power
switch on the heat output vent assembly (C) to the I
position .
1
B
Master
Power Switch
2 . Turn the fan switch to the on position . Then select a
heat setting by pressing the 500 W heat buttons on
the control panel (C) .
Power one heat mode for 500 W; power both heat
modes for 1,000 W .
2
B
Fan
Switch
500 W 500 W
3 . Set the thermostat by turning the thermostat knob on
the control panel (C)
To increase the desired temperature, turn the
thermostat dial to the right (clockwise) to increase, or
left to decrease temperature . The thermostat control
knob can only be used while the Power and Heat
switch/switches are in the on position .
Once you have chosen the desired temperature,
the heater will remain on until the room temperature
increases to that level . Then, the heater will cycle on
and off to maintain the desired room temperature .
3
B
Clockwise
4 . To adjust the flame effect brightness, turn the dimmer
dial clockwise or counter clockwise . The dimmer
switch can only be used when the power switch is in
the ON position .
4
B
Clockwise