Losi LOSB0013 Getting Started Guide User Manual

Getting started

Advertising
background image

5 cell RX Pack

GETTING STARTED

GETTING STARTED

NOTE:

Before you start running your Mega Baja™, read your engine break-in and operating
instructions. If you run your Mega Baja without following proper break-in procedure,
you may damage or fail to get maximum performance from your engine, and void the
warranty.

Page 

Plug the AC charger into the proper 110V wall receptacle.
Plug the charger into the battery pack. When the battery
is charging the Red indicator light will be on. A discharged
battery will need to be charged for 10-12 hours to attain a
full charge.

Find the antenna tube in the plastic bag with the
Operations guide. Thread the black antenna wire attached
to the receiver through the mounting boss (fig. 1A) on the
right side of the radio box and through the antenna tube.
Push the antenna tube (fig. 1B) into the mounting boss on
the side of the radio box.

Install the 8 AA-size alkaline batteries in the transmitter
making sure the positive (+) and (-) negative ends are
oriented correctly. Use only quality alkaline or rechargeable
Ni-MH (nickel-metal hydride) AA size cells.

To install a rechargeable battery pack, turn the chassis over
and using the included 1/16” Allen wrench, remove the four
screws (fig. 4A) securing the battery mount. Install the battery
pack (fig. 4B) with the plug and wires going through the
grommet hole (fig. 4C) in the chassis. Re-install the battery
mount and the four screws that secure it. Plug the battery
lead (fig. 4D) into the wire harness.

Radio Batteries

5-Cell Receiver Pack

1A

3

1B

4A

4C

4B

4D

2

Receiver Battery

Antenna Tube

Advertising