Losi LOSB0126 User Manual

Page 3

Advertising
background image

3

Always operate your model in an open area away from

people and cars. The potential speed of this model can

cause injury or damage.

Never operate your Ten-T with low transmitter or receiver

batteries – especially AA dry cells as control and power will

be limited.

Repeated or prolonged use of heavy braking will cause the

brakes to overheat and fail! Always leave plenty of room

for stopping.

It will take as much room to stop as it does to accelerate to

speed. Always run in an open area with plenty of braking

room.

Special Warnings about the LiPo battery

used in this model:

While the 2S 7.4V 1000mAh Lithium Polymer Battery

(LOSB9818) included with your Ten-T features Charge

Protection Circuitry and optional Balance Charging you MUST

read the following safety instructions and warnings before

handling, charging or using this LiPo battery. Always follow the

manufacturer’s instructions when disposing of Lithium Polymer

batteries.

Note: Lithium Polymer batteries are significantly

more volatile than the alkaline, NiCd or NiMH

batteries used in RC applications. All instructions and

warnings must be followed exactly. Mishandling of

LiPo batteries can result in fire. By handling, charging

or using the included LiPo battery you assume all

risks associated with lithium batteries. If you do not

agree with these conditions, return your complete

Ten-T model in new, unused condition to the place of

purchase immediately.

Never let the LiPo receiver battery discharge completely –

you can monitor this on the radio screen. When you see it

is getting low stop and recharge. Failure to do so will ruin

the battery and it cannot be recharged.

You must charge the included 2S 7.4V 1000mAh LiPo

battery in a safe area away from flammable materials. The

LOSB9700 LiPo Protection Pouch is suggested.

Do not charge the battery when installed in the model.

Never charge the battery unattended. When charging you

should always remain in constant observation and be able

to react to potential problems that may occur.

Keep hobby knives and sharp objects away from LiPo

batteries. Puncturing will cause damage and can result in

fire.

After use, the battery must be cooled to ambient air

temperature before charging.

You MUST use a LiPo specific charger similar to the one

included with the Ten-T. Failure to do so may result in a fire

causing personal injury and/or property damage.

DO NOT USE AN NiMH/NiCd charger under any

circumstance.

Always follow the charging directions and never charge at

more than 1 amp. Failure to do so could result in a fire.

If at any time during the charge or discharge process

the battery begins to balloon or swell, stop charging or

discharging immediately. Quickly and safely disconnect

the battery and place it in a safe open area away from

flammable materials to observe it for at least 15 minutes.

Continuing to charge or discharge a battery that has

begun to balloon or swell can result in a fire. A battery that

has ballooned or swollen even a small amount must be

removed from service and disposed of safely.

Store the battery at room temperature with no less than

½ charge (3.7V per cell; 7.4V for a 2S battery pack) for best

results. Never store the battery discharged.

When transporting or temporarily storing the battery,

the temperature range should be from 40–120 degrees

Fahrenheit. Do not store the battery or model in a car or

direct sunlight. If stored in a hot car, the battery can be

damaged or even catch fire.

Although the battery included with the Ten-T has a low

voltage circuit included which prevents over-discharging

the battery, you should never discharge the battery below

6.1V during use (3V per cell).

The included battery also uses a 25-amp draw protection

cutoff that occurs when the battery is under load. If this

occurs you must correct the reason for the high current

draw (usually the starter motor being stalled) and reset the

cutoff by turning the receiver in the model “Off” then “On”

again.

Always be careful to observe the proper polarity when

charging or using the battery.

Be careful not to short the output or balance leads.

Do not ever try to disassemble the pack.

For best performance balance the pack periodically.

If you have any further questions or concerns regarding

the handling, charging and/or use of the included LiPo

battery pack, please contact Horizon Hobby’s Product

Support staff. Contact information can be found in the

warranty section of this manual.

Advertising