Losi LOSB0205 Quick Start - Manual

Page 
Getting Started
NOTE:
Getting Started
Step 1
Step 3
Step 2
Before you start running your new Mini-Slider, it is absolutely necessary that you read
through all of the operating instructions to prevent unnecessary damage and get the
maximum enjoyment from your vehicle.
Plug the AC charger into the proper wall receptacle (0V).
Plug the battery pack into the charger and let it charge for
3 hours for the first time. After running, or when the Mini-
Slider slows noticeably, recharge the battery pack for 5 to 6
hours for a full charge.
Remove the transmitter battery cover by sliding the cover
from left to right. Install four (4) AA batteries into the
battery holder. Pay close attention to the correct direction
of the positive (+) and negative (-) ends as marked in the
tray. Once all 4 batteries have been installed, reinstall the
battery cover by sliding it on from right to left.
Once the battery is charged, remove the body clip
from the front battery hold down and remove the
battery strap (fig. 1).
Install the charged battery pack into the chassis as
shown (fig.2). Ensure that the battery is laying flat on
the chassis.
Reinstall the battery strap and body clip. Plug the
battery pack into the ESC (fig. 3).
Fig  Fig 2
Fig 3
Mini Slider QSG A4.indd 1 5/2/2007 2:31:15 PM