Losi LOSB0217 Getting Started - Manual

Page 
Getting Started
NOTE:
Getting Started
Step 1
Step 3
Step 4
Step 2
Before you start running your new Mini-LST2, it is absolutely necessary that you read
through all of the operating instructions to prevent unnecessary damage and get the
maximum enjoyment from your vehicle.
Plug the AC charger into the proper wall receptacle (0V).
Plug the battery pack into the charger and let it charge for 3
hours for the first time. After running, or when the Mini-LST2
slows noticeably, recharge the battery pack for 5–6 hours for
a full charge.
Remove the transmitter battery cover by sliding the cover
from left to right. Install four (4) AA batteries into the battery
holder. Pay close attention to the correct direction of the
positive (+) and negative (-) ends as marked in the tray.
Once all four batteries have been installed, reinstall the
battery cover by sliding it on from right to left.
The DSM ® receiver has a short antenna that can be positioned
underneath the body as shown in Fig. 
Once the battery
is charged,
remove the body
clip from the front
of the battery tray
(fig. 2) and lift
up the front of
the tray (fig. 3).
Install the battery
pack as shown
(fig. 4), reinstall
the body clip and
plug the battery
pack into the
ESC.
Fig 1
Fig 2
Fig 3
Fig 4