Losi LOSB0289 Drift R Manual - Manual (Page 25)

112
108
113 111
105
104
106
107
110
109
108
104
2 2
Figure 49
Figure 50
!
Step 1. Place one shock O-ring (105) into the cartridge body
(104), making sure that the O-ring (105) sits flat in the bottom of the
cartridge body (104).
!
Step 2. Insert the cartridge spacer (106) into the cartridge body
(104) followed by a second O-ring (105).
!
Step 3. Once the second O-ring (105) is inserted, and is flush with
the top of the cartridge body (104), press the cartridge cap (107) onto
the cartridge body (104).
!
Step 4. Make four cartridge assemblies.
Cartridges in some kits may be pre-assembled at the factory.
Figure 49
Figure 50
Figure 51
Figure 51
105 106
BAG F
!
Step 5. Place a drop of shock fluid (115) on the grooved end of
each shock shaft (108) and slide a cartridge , hex end first, down the
shock shaft towards the threads as shown in Figure 50 on all four
shafts (108).
!
Step 6. Using pliers or small vise grips, grasp the shock shaft
(108) between the grooves and thread a shock end (109) all the way
onto the shaft (108) until the threads stop.
!
Step 7. Repeat Step 5-6 on all four shock shafts (108).
!
Step 8. Carefully snap a 1/4" shock mount ball (110) into each of
the shock ends (109) on each of the four shock shafts (108).
108 110
!
Step 9. Snap a 1/8" E-clip (112) into the groove closest to the
cartridge on both front and rear shock shafts (108).
!
Step 10. Slide a "red", #56 shock piston (113) onto two shock
shafts (108) until the piston (113) rests against the E-clip (112). Secure
the pistons (113) to the shafts (108) with a second E-clip (112). These
will be used on the front.
!
Step 11. Slide an "orange" #55 shock piston (111) onto each of
the rear shock shafts (108) until the piston rests against the E-clip
(112). Secure the pistons (111) to the shafts (108) with a second E-clip
(112). These will be the rear shocks.
Front
Rear
112