Losi LOSK0800 - Manual (Page 33)

30
A9316
Fuel Line
Clip
Adjust the Gear mesh between the Clutch Bell and the Spur Gear by
sliding the Engine Mounts in the slots of the Chassis. In order to function
properly, the Gears should be as close as possilbe, but still have a small
amount of backlash (space between the Gear teeth).
Place a piece of paper between the Clutch Bell Gear and Spur Gear, Slide
the engine sideways until the paper is pinched between the Gears and
Tighten the engine mount Screws. This will give a small amount of space
between the gears.
You should be able to rock one Gear back and forth slightly while holding
the other one steady. Be sure to check the Gear mesh all the way around
the Spur gear.
Once the engine alignment and Gear mesh are correct, tighten all of the
Screws. Re-check the Gear mesh after all the Screws are tight to ensure the
Engine Mounts did not move. •
•
•
•
BAG G BAG G
Engine Installation STEP G-07
‰
Fuel Tube/Completed Engine Assy. STEP G-08
‰
8-32 x 1/2”
x 4
#8 Countersink
x 4
(Not included)
1
2
Body Clip
x 1
x 1
Supplied with
pipe