Navi ga tio n, Map functions – Mercedes-Benz S-Class 2014 COMAND Manual User Manual
Page 116
Avoiding an area
General information
COMAND enables you to avoid areas you do not wish to drive through.
If you activate or deactivate a route block while route guidance is active, COMAND will
calculate a new route. If you activate or deactivate a route block while route guidance is
inactive, COMAND will use the new setting for the next route guidance.
The calculated route may contain an area to be avoided if the destination is in such an area.
i
Highways within blocked areas are always taken into consideration in the route calculation.
Avoiding a new area
X
To switch to navigation mode: press the ß button.
X
To show the menu: press the controller.
X
To select
Options
Options
: turn and press the controller.
X
Select
Route Settings
Route Settings
.
X
Select
Avoid/Use Options
Avoid/Use Options
.
X
Select
Avoid Area
Avoid Area
.
X
Select
Avoid New Area
Avoid New Area
.
A menu appears.
X
Select
Using Map
Using Map
or
Address Entry
Address Entry
.
If you select
Using Map
Using Map
, the map with crosshair appears.
If you select
Address Entry
Address Entry
, the address entry menu appears where you can enter the
address (
Y
page 75). The map appears with the crosshair after the address is entered.
X
To select an area: when the map with crosshair appears, press the controller.
A red square appears on the map, symbolizing the area to be blocked.
X
To change the size of the area, turn the controller.
The map scale is shown at the bottom of the display. The needle is on the map scale currently
selected.
X
When the desired size is set, press the controller.
The area is entered into the list.
114
Map functions
Navi
ga
tio
n