Mercedes-Benz CLS-Class 2014 COMAND Manual - Manual (Page 48)

R Detour Menu Detour Menu : you can call up the Detour
menu and then block a section of the route
and recalculate the route (
Y
page 92).
R Compass Compass Screen Screen : you can call up the com-
pass.
R Driver's Seat Massage Driver's Seat Massage , Front-Pas‐ Front-Pas‐
senger's Seat Massage senger's Seat Massage or Massage: Massage:
Both Both Front Front Seats Seats : you can start the mas-
sage function, depending on which seats
are selected (
Y
page 52).
Importing/exporting data
General notes
! Never remove the stick or card when writ-
ing data to the USB stick or the memory
card. You may otherwise lose data.
Using this function, you can:
R transfer your personal COMAND data from
one system/vehicle to another.
R make a backup copy of your personal data
(export data) and load it again (import
data).
R protect your data from unwanted export by
activating a pin prompt (presetting: deacti-
vated ª).
You can either use an SD memory card or a
USB storage device (e.g. a USB stick) as tem-
porary storage.
Activating/deactivating PIN protec-
tion
X Press the W button.
The system menu appears.
X Select Settings Settings by turning cVd the
COMAND controller and press W to con-
firm.
X Select Import/Export Data Import/Export Data and press
W to confirm.
X Select Activate PIN Protection Activate PIN Protection and
press W to confirm.
Activate O or deactivate ª PIN protec-
tion. When activating PIN protection, you
will be prompted to enter a PIN.
X Enter a 4-digit PIN, select¬and press
W to confirm.
You will be prompted to enter the PIN
again.
X Re-enter the PIN, select ¬ and press
W to confirm.
The PIN prompt now protects your personal
data from unwanted export.
i If you deactivate your PIN protection, you
will first be prompted to enter your PIN. If
you have forgotten your PIN, a Mercedes-
Benz service station can deactivate your
PIN protection for you. Alternatively, you
can deactivate PIN protection by resetting
your personal COMAND data
(
Y
page 47).
46
Importing/exporting data
System
settings