Activating/deactivating air-recirculation mode, Activating/deactivating the residual heat function, Setting the air vents – Mercedes-Benz G-Class 2012 Owners Manual User Manual

Page 112: Important safety notes, To activate/deactivate the residual heat function, To activate/deactivate air-recirculation mode, Climate control

Advertising
background image

Activating/deactivating air-

recirculation mode

You can deactivate the flow of fresh air if
unpleasant odors are entering the vehicle
from outside. The air already inside the
vehicle will then be recirculated.

G

WARNING

Fogged windows impair visibility,
endangering you and others. If the windows
begin to fog on the inside, switching off the
air recirculation mode immediately should
clear interior window fogging. If interior
window fogging persists, make sure the air
conditioning is activated, or press button
z or ¥.

X

Turn the SmartKey to position

2 in the

ignition lock.

X

To switch on: press the g button.
The indicator lamp in the g button lights
up.

i

Air-recirculation mode is activated

automatically at high outside
temperatures. When air-recirculation mode
is activated automatically, the indicator
lamp in the g button is not lit.
Outside air is added after about 30
minutes.

X

To switch off: press the g button.
The indicator lamp in the g button goes
out.

i

Air-recirculation mode switches off

automatically:

R

after approximately five minutes if
outside temperatures are less than about
41 ‡ (5 †)

R

after approximately five minutes if
cooling with air dehumidification is
deactivated

R

after approximately 30 minutes if outside
temperatures are over about
41 ‡ (5 †)

Activating/deactivating the residual

heat function

It is possible to make use of the residual heat
of the engine to continue heating the
stationary vehicle for up to 30 minutes after
the engine has been switched off. The heating
time depends on the coolant temperature and
on the interior temperature that has been set.

i

The blower will run at a low speed

regardless of the airflow setting.

i

If you activate the residual heat function

at high temperatures, only the ventilation
will be activated.

X

Turn the SmartKey to position

0 in the

ignition lock or remove it.

X

To activate: press the Á button.
The indicator lamp in the Á button lights
up.

X

To switch off: press the Á button.
The indicator lamp in the Á button goes
out.

i

Residual heat is deactivated

automatically:

R

after about 30 minutes

R

when the ignition is switched on

R

if the battery voltage drops

R

if the coolant temperature is too low

Setting the air vents

Important safety notes

G

WARNING

When operating the climate control, the air
that enters the passenger compartment
through the air vents can be very hot or very
cold (depending on the set temperature). This
could cause burns or frostbite to unprotected
skin in the immediate area of the air vents.
Always keep sufficient distance between
unprotected parts of the body and the air
vents. If necessary, use the air distribution

110

Setting the air vents

Climate control

Advertising