Mercedes-Benz M-Class 2011 Owners Manual - Manual (Page 304)

TIREFIT kit version 1
X Open flap ;.
X Pull connector A with the cable and hose
B out of the housing.
X Screw hose B onto flange C of TIREFIT
sealant filler bottle :.
X Place TIREFIT sealant filler bottle : head
downwards into recess = of the electric
air pump.
X Remove the cap from valve E on the faulty
tire.
X Make sure pressure release screw F on
pressure gauge G is fully closed.
X Screw filler hose D onto valve E.
X Insert connector A into the socket in the
footwell of the 2nd row of seats
(
Y page 269).
! None of the other sockets or cigarette
lighters are designed for operating the
electric air pump.
X Turn the key to position 1( Y page 139) in
the ignition lock.
X Press on/off switch ? on the electric air
pump to
I.
The electric air pump is switched on. The
tire is inflated.
i First, TIREFIT is pumped into the tire. The
pressure can briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the electric pump
during this phase.
X Let the electric pump run for five minutes.
The tire should then have attained a
pressure of at least 180 kPa (1.8 bar/
26 psi).
G Warning
The air hose can become hot during inflation.
Please exercise appropriate caution.
! Do not operate the electric air pump for
longer than eight minutes at a time without
a break. It may otherwise overheat.
The air pump can be operated again once
it has cooled down.
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) has been achieved, see
(
Y page 304).
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved, see
(
Y page 303).
302
Flat tire
Roadside assistance
BA 164.1 USA, CA Edition B 2011; 1; 2, en-US
d2mskot
Version: 3.0.3.5
2010-04-21T17:25:06+02:00 - Seite 302