Comand, Navigation – Mercedes-Benz CL-Class 2011 User Manual
Page 148
Entering an intermediate stop
Introduction
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
categories that COMAND offers for selection:
R
Mercedes-Benz Service Center
R
Hospital
R
Gas Station
R
Parking Lot
R
Restaurant
However, you can also enter destinations
other than the predefined ones. To do this,
select the menu item
Other
.
You can use the intermediate stop function to
influence route guidance to the main
destination. When you have reached your
intermediate stop, COMAND automatically
recalculates the route to the main
destination.
Entering predefined destinations
X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press the COMAND
controller W.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select
Stopover
and press W to confirm.
Option 1: no intermediate stop has been
entered yet.
X
Select a category, see option 2.
Option 2: an intermediate stop has
already been entered.
X
Select
Change Stopover
and press W to
confirm.
X
To select a category: select a category by
turning cVd the COMAND controller and
press W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of up to 100 km (approx. 60 mi) of
the vehicle position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display.
The intermediate stops are listed according
to increasing distance from the current
vehicle position. They are displayed in the
form of a name and their position in relation
to the route and your direction of travel.
i
For intermediate stops that are not
located along the calculated route, the
linear distance is shown.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm
OK
by pressing W.
X
Select a different category.
X
Select the intermediate stop by turning
cVd the COMAND controller and press
W to confirm.
X
To start route calculation: select
Start
and press W to confirm.
Entering another destination as an
intermediate stop
X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press the COMAND
controller W.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select
Stopover
and press W to confirm.
X
Select
Other
and press W to confirm.
146
Navigation
COMAND