Controls in detail – Mercedes-Benz SLK-Class 2009 Owners Manual User Manual
Page 218
Useful features
216
not be long enough for the integrated signal
transmitter to pick up the signal during pro-
gramming. Similar to this Canadian law, some
U.S. gate operators are designed to “time-
out” in the same manner.
If you live in Canada or if you are having dif-
ficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
X
Step 4: Press and hold the signal transmit-
ter button (
2
,
3
or
4
). Do not release
this button until it has been successfully
trained.
X
While still holding down the signal trans-
mitter button (
2
,
3
or
4
), “cycle” your
hand-held remote control button
6
as fol-
lows: Press and hold button
6
for 2 sec-
onds, then release it for 2 seconds, and
again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator lamp
1
will flash slowly and then rapidly after
several seconds.
X
Proceed with programming step 5 and
step 6 to complete.
i
Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future pro-
gramming of an integrated remote control,
or simply for continued use as a hand-held
remote control to operate the respective
device in other situations.
Reprogramming a single signal trans-
mitter button
To program a device using a signal transmit-
ter button previously trained, follow these
steps:
X
Switch on the ignition.
X
Press and hold the desired signal transmit-
ter button (
2
,
3
or
4
). Do not release
the button.
Indicator lamp
1
will begin to flash after
20 seconds.
X
Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
Operation of integrated remote control
X
Switch on the ignition.
X
Select and press the appropriate inte-
grated signal transmitter button (
2
,
3
or
4
) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
Erasing the integrated remote control
memory
X
Switch on the ignition.
X
Simultaneously press and hold outer signal
transmitter buttons
2
and
4
, for approx-
imately 20 seconds, until indicator lamp
1
flashes rapidly. Do not hold for longer
than 30 seconds.
The codes of all three channels are erased.
i
If you sell your vehicle, erase the codes of
all three channels.
Controls in detail