Mercedes-Benz G-Class 2008 Owners Manual - Manual (Page 394)

393
Practical hints
Flat tire
1 - 5 Wheel bolts
̈ Tighten the five wheel bolts evenly,
following the diagonal sequence illus-
trated (1 to 5), until all wheel bolts
are tight. Observe a tightening torque
of 96 lb-ft (130 Nm).
̈ Disassemble the pump handle
(
୴ page 390).
̈ Put the pump handle and the wheel
wrench back into the vehicle tool kit.
̈ Store the vehicle tool kit in the
designated storage compartment
(
୴ page 364).
̈ Press the jack piston in again and close
the lowering screw (
୴ page 390).
̈ Store the jack in the designated
storage compartment (
୴ page 365).
̈ After changing the wheel, secure the
damaged wheel on the spare wheel
carrier (
୴ page 367). Make sure the
wheel cannot come loose.
̈ Check the tire inflation pressure and
correct it if necessary.
Follow recommended cold tire inflation
pressures listed on the Tire and
Loading Information placard on the
driver’s door B-pillar (
୴ page 280).
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).
W463.boo Seite 393 Montag, 19. November 2007 8:41 08