Mercedes-Benz SLR-Class 2005 - Manual (Page 132)

131
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with button
æ or ç to the
Lighting sub-
menu.
̈ Press button j or k repeatedly
until you see this message in the left
display:
Light circuit Headlamp
mode .
The selection marker is on the current
setting.
̈ Press button æ or ç to select
manual operation ( Manual ) or daytime
running lamp mode ( Constant )
activated.
With daytime running lamp mode activated
and the exterior lamp switch in
position
M or U, the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
For more information on the daytime
running lamp mode, see “Daytime running
lamp mode” (
୴ page 107).
i
This function is not available in
countries where the daytime running
lamp mode is mandatory and therefore
in a constant mode.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting submenu to factory settings
( ୴ page 126) will not reset the daytime
running lamp mode.
In the right display you will then see the
message:
Cannot be fully reset to
factory settings while driv.! .