CLIFFORD XL2000 - Manual (Page 10)

User-Selectable Features
Your XL2000 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just flick the valet switch a few times.
The system comes from the factory with all of its features pre-programmed as noted
in the table below and on page 10. To change any of the settings, use the
procedure noted. To restore the feature to its factory setting, just repeat the
procedure:
1. Select the feature you wish to program from the table on the following
pages. Note the number of flicks and chirps associated with that feature.
2. Insert your ignition key and turn it to the “ON” position.
3. Immediately flick the valet switch back and forth, counting the number of
chirps you hear. Stop when you reach the appropriate number of chirps
4. If noted, do the “secondary action.”
5. You will hear one or more chirps (as noted in the “program completion con-
firmation" section) to confirm that you have changed the feature setting.
Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Programming Table for User-Selectable Features
Feature
Factory
setting
# of
flicks &
chirps
Secondary
action
Program
completion
confirmation
Result
AutoArming ON 4 —
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
AutoArm
& Lock
OFF 5 —
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Arm/Disarm
Chirp Confir-
mation
ON 6 —
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Chirp
Volume
Full
Volume
7 —
1 chirp 3
seconds after
last step
Changes state from
LOUD to SOFT volume or
vice-versa
Headlights
On Reminder
ON 8 —
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
AutoLock/
AutoUnLock
ON 9 —
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
9