Miller Compass 25 - Manual (Page 11)

11
The Compass 25 Fluid Head can be stored for extended periods;
Miller recommends storage in a Miller Soft Case and the following:
• Remove
battery.
•
Clean the external surfaces.
•
Keep in a dry place away from direct sunlight.
•
Loosen off PAN & TILT LOCK.
S P A R E P A R T S A N D A C C E S S O R I E S
ITEM ITEM NO.
Battery P7715
Camera plate Assembly (Including 3/8” +
1/4” screws)
#860
Camera screw 3/8” P0037
Camera screw 1/4” P0036
1/4” + pin carriage #493
Telescopic Pan Handle assembly
(including Handle Clamp)
#694
Telescopic Pan Handle #692
Soft Case #876
Clamp nut P3836
Accessory Mounting Bracket Ass’y #1216
Accessory Mounting Adaptor Ass’y #1217
W A R R AN T Y
Please refer to warranty card for complete details.
Miller Authorised Service Agents must carry out all service and
repair work. Failure to observe this requirement may void
warranty. It is advisable to notify Miller or a Miller Authorised
Service Agent if a change of performance is observed as a
result of dropping or rough usage. For information regarding
sales and service of Miller products or for your nearest Miller
representative please contact us via our website or at the
following:
MILLER CAMERA SUPPORT EQUIPMENT
30 Hotham Parade, Artarmon, Sydney,
NSW 2064 Australia
Tel: +61 2 9439 6377 Fax: +61 2 9438 2819
Email:
[email protected]
MILLER Camera Support (LLC) USA
218 Little Falls Road, Cedar Grove, New Jersey 07009-1231
USA
Tel: (973) 857 8300 Fax: (973) 857 8188
Email:
[email protected]
MILLER FLUID HEADS (EUROPE) LTD.
Unit 12A, Shepperton Business Park
Govett Avenue, Shepperton, Middlesex TW17 8BA,
United Kingdom
Tel: +44 (0)1243 555255 Fax: +44 (0)1243 555 001
Email:
s a l e s @ m i l l e r t r i p o d s - e u r o p e . c o m
WEBSITE-
w w w . m i l l e r t r i p o d s . c o m
Storage
Service, Sales and Support