Miller Combination Pedestal - Manual (Page 5)

SET-UP (CONT)
EXTENDED SET-UP (optional)
The Pedestal can be enlarged using the optional VPS-300 extension (Fig 10.). This
will extend the base height of your pedestal by 300mm.
Placing Extension:
• Remove the three locking screws that hold the column in the base piece using
the supplied hexagon key.
• Take off the Column with spider and lay it aside.
• Mount the extension you need using the same hexagon key.
Take the Column and mount it on top of the extension. •
Fig 10.
Loosen the Spider Clamp Ring •
with the two locking screws and let
it slide down until the spider legs
fit the ball of dolly end. Then
fasten the Spider Clamp Ring
again with both screws.