Modern AG 10' Offset Flex Predator - Manual (Page 65)

10’ Offset Predatorrr - 65
MAintenAnce section
Pto sHAFt MAintenAnce
All points should be lubricated every 8 hours of use
• For maximum life and performance, the CV body muSt be greased regularly. Lubrication with the
driveline is a straight position - up to 30 pumps of grease may be required.
• the metal drive tubes muSt be greased to operate properly.
• Shielding is subject to damage from abuse and weathering. Replace aLL damaged components
and ALL shielding removed during maintenance
• DO nOt use PtO adapter with CV drivelines. Replace special taper Pin bolts only with genuine
Oem parts, periodically check tightness of nuts.
• Consult Operator’s manual for additional information
The CV joint must be greased every 8 hours
(shield bearings, cross journal, and internal
parts) as indicated in the grease diagrams.
To disassemble, remove the hardshell shield
by removing the screws, then remove the cross
journal in the same manner used for ordinary
universal joint.
Careful attention must be paid to the
geometry of the cross journal when replacing.
The body is asymmetrical concave part must
face towards the body with the grease nipple
to the outside.