Modern AG Disk Harrow - Manual (Page 5)

Standard Disc Harrow- 5
FIGURE 5
FIGURE 6
Step 1. Place front right and left gangs in following posi-
tion so that they cut and push the dirt away. (Figure 1)
Step 2. Then place left and right rear gangs in the fol-
lowing position so they will cut and pull the dirt back.
(Figure 1)
Step 3. Remove the (8) U-bolts, washers, nuts, from the
bearing arm. (Figure 2)
Step 4. Place the disc frame onto the front and rear gangs.
(Figure 3) Install U-bolts across disc frame through bear-
ing arm. Secure with lockwasher and nut provided.
Repeat step until all gang arms are attached to disc frame.
(Figure 4)
Step 5. Once all gang arms are attached and in desired
location, tighten securely.
Step 6. Bolt hitch to frame as shown with hardware pro-
vided. Do not tighten all bolts until the hitch is assembled.
(Figure 5)
Gang Angle Adjustment
Remove Click pin and pull pin. Adjust front and/or
rear gangs using the holes in the adjustment bracket.
(Figure 6)
ASSEMBLY SECTION
FIGURE 4