Modern AG Grapple - Manual (Page 11)

Grapple - 11
ASSemBly SeCTiON
remOviNG THe TiNe Or
SCrAP GrAPPle BuCKeT
Serious injury or death may result from disengaging
the attachment when the attachment is in an unstable
position or carrying a load. place the attachment in a
stable position before disengaging.
Hoses for the attachment must be disconnected before
the quick attach is disengaged. pulling the attachment
with the hoses could result in damage to the prime
mover or the attachment.
1. If possible, find a level solid location to place the
attachment. This makes it easier to disconnect and to
re-connect later on.
2. Lower the attachment to the ground.
3. Engage the parking brake and shut down the prime
mover. Be sure to relieve pressure to the auxiliary
hydraulic lines.
4. Unfasten safety restraints and exit prime mover.
5. Disconnect the attachment hydraulic lines from the
prime mover. Connect quick couplers together to
keep clean.
6. Disengage attachment-locking mechanism
(mechanical type).
7. Enter prime mover, fasten safety restraints and start
the prime mover.
8. Disengage attachment-locking mechanism
(hydraulic type).
9. Disengage the parking brake, and back away from
the attachment.
WArNiNG
CAuTiON