Modern AG Industrial Box Scraper - Manual (Page 7)

Industrial Box Scrapperrr - 7
BaCkfilliNG
adjust scarifier teeth to upper position. Level scrap-
er front-to-rear by adjusting tractor center link.
Push dirt with rear cutting edge.
traCtOr aDJUstMeNts
See your tractor operator’s manual for the follow-
ing:
Drawbar: Put drawbar in short position.
Leveling: Level cutting edge side-to-side using
tractor life link. Level front-to-rear by turning trac-
tor center link.
Rate to Drop: adjust rate-to-drop so it is enough
to be safe.
Sway control: adjust anti-sway chins on 3-point
hitch to prevent scraper from swaying.
Float: adjust draft links for lateral float to allow
scraper to float over objects or uneven ground.
reversiNG Or rePlaCiNG
CUttiNG eDGe
CaUtiON: Before you work on cutting edge:
-Put blocks (or stands) under frame.
-lower scraper onto blocks.
-replace damaged or missing hardware.
Remove bolts from cutting edge.
Reverse or replace cutting edge.
Fasten cutting edge with bolts.
stOriNG the sCraPer
If possible, store scraper in a dry place on a hard
surface.
Protect scraper from ground moisture (blocks).
Clean box and frame.
Replace worn or damaged parts.
tighten loose hardware.
apply touch-up paint to prevent rust.
Put a protective cover over scraper if you store it.
OPeratiON