Origin Live All MK3 Decks - Manual (Page 2)

Page 2
I N T R O D U C T I O N
Read Carefully - Congratulations and thankyour for
choosing an Origin Live turntable. You now have one of the
finest sounding turntables available – not only will it provide
an extraordinary level of performance but also reliability and
low maintenance. These instructions cover all decks listed on
the front cover, so photos and diagrams are for illustration
only. Specific instructions for a particular deck are always
included.
Critical performance factors should be noted as follows:
Adjustable feet to be clear of plinth underside
Belt tension affects speed slightly so do not move pod once
speed is set
The portions of the instructions printed in italics are optional
reading that provide additional information. It is critical that
the remainder of the instructions are read fully to achieve
full potential performance. Underlined text is especially
important.
Although the instructions are written for owners with no
previous experience of turntables, there are aspects of the deck
that run contrary to expections, so experts should note that
before altering anything it is important to have fully read the
“italics” instructions or degradation will result.
An Origin Live turntable is very simple to set up. These
instructions appear lengthy because they cover trouble
shooting and give proper explantion of factors that are
different to conventional set ups. If you have a problem, please
refer to the instructions - failing this, you should speak to your
dealer or refer to technical support on the Origin Live web
site www.originlive.com - See top navigation bar “ support”.
Your pre-assembled deck is illustrated below and you should
not dismantle it. We wish you an enjoyable time with your
Origin Live turntable.
P A R T S L I S T
Check that all parts are present.
 Plinth & Sub-chassis - including 1 cable clip
with nut & bolt.
 Turntable bags
o Cork washer for arm & acrylic disc
o Oil bottle
o screwdriver
o 2.5mm allen key for arm clip
o 4mm Allen key & 8mm A/F spanner
(All 12” armboard versions, Resolution &
Sovereign only for sub-chassis attachment)
o 2 plastic + 1 steel foot (Sovereign only)
 Platter
 Upgrade platter mat
 (Sovereign only) Sub-platter
 1 Belt + Spindle for platter + Strobe card
 Motor pod
 Standard or  upgrade transformer for 230 volt
or 110 volt mains supply
 Turntable instructions
A V O I D S C R A T C H I N G T H E
H I G H G R A D E F I N I S H
To clean the surface use a soft lint free cloth
such as a duster – do not use tissue paper or
kitchen towel as these are mildly abrasive.
DECK PRIOR TO INSERTING PLATTER
or Sovereign