Origin Live Sovereign - fitting the 12 inch sub-chassis and all other subchassis - Manual

Assembly of Sovereign sub-chassis to plinth
The Sub-chassis of the deck is not assembled prior to transit to prevent potential distortion
that can occur when it is rigidly attached to the plinth. Please fit the Sub-chassis to the
plinth following the instructions on these sheets.
Preliminary notes The sub-chassis is carefully built such that the platter runs true to the
armboard so do not tamper with any of the bolts on the sub-chassis even if they may not
appear to be seriously tight.
On the Resolution and Sovereign decks - When you finally level the deck, note that the
acrylic part of the armboard is not a reference surface – only the chrome inner disc is true
to the platter level.
Illustration of turntable as packed before final assembly
Plinth
Pivot bolt
Inertia disc
Pivot Spacer
Pivot nut
Anti-rotate stud Hole
The deck arrives as shown above. To attach the
sub-chassis to the deck carry out the following:
Place the deck on edge as shown in photo. Undo
the Pivot nut using the box spanner on the nut
and allen key on the bolt head underneath the
deck.
Once the nut is removed, do not allow everything
to fall apart. Hold the anti-rotate bolt from falling
out.