Pridiom PGD1080HCW - Manual (Page 8)

8
US
CONTROLS
Functions:
ON/OFF
The unit is switched on and off by pressing the ‘ON/OFF’ button. When the
unit is on, the fan runs in the set speed.
Humidity
Press the ‘HUMIDITY ADJUST’ buttons repeatedly to choose the desired level
of relative humidity in the area. The corresponding control lights will indicate
the selected percentage. The ‘CONT’ control light indicates that the unit is
running continuously, disregarding the relative humidity level in the area.
Note: When the desired level of humidity is achieved the compressor will stop
however, the fan will continue to run for approximately 15 minutes, this will
clear the heat exchanger of all collected water.
Fan speed
Press the ‘FAN SPEED SELECT’ button to select low or high speed. The cor-
responding control light will indicate this, Lo=low or Hi=high.
Humidity / Temperature display
The digital display will normally show the measured relative humidity in the
area.
Your Pridiom dehumidifier features a microprocessor based digital control
system for optimal performance control.
All functions are accessible via the membrane keypad shown below:
US
Humidity
Setting
Display
Humidity
Adjust
Humidity &
Temperature
Display
Timer
Set
Display
Select
On/Off
Select
Fan Speed
Select
Fan Speed
Display
Temperature