Pridiom Floor and Ceiling PFCM183HX Remote Control Manual - Manual (Page 4)

Function buttons(continued)
5 5 6 6
12
13
TURBO
Active/Disable Turbo function. Turbo function
enables the unit to reach the preset temperature
in the shortest time. When press this button
on heating mode(applicable to the unit adopts
PTC only), the PTC will be energized and bring
fast heating operation.
Used to select the fan speed in four steps:
AUTO LOW MED HIGH
FAN SPEED Button
LED Button
Disable/Active indoor screen Display.
11 DOWN Button
Push this button to decrease setting temperature
or to decrease Hour during Clock time setting.
NOTE: Press and hold UP and DOWN buttons
together for 3 seconds will alternate the temper-
O O ature display between the C & F scale.
9
10 UP Button
Push this button to increase setting temperature
or to increase Hour during Clock time setting.
13
TIMER ON Button
Press this button to activate the Auto-on time
setting. Each press will increase the time setting
in 30 minutes increments, up to 10 hours, then at
1 hour increments up to 24 hours. To cancel the
Auto-on time setting, just press the button until
the time setting is 0.0.
TIMER OFF Button
15
Press this button to activate the Auto-off time
setting. Each press will increase the time setting
in 30 minutes increments, up to 10 hours, then at
1 hour increments up to 24 hours. To cancel the
Auto-off time setting, just press the button until
the time setting is 0.0.
CLOCK Button
Used to set the remote clock.
16
NOTE:
Buttons design might be slightly different
from the actual one depending on individual
models.
All the functions described above are
accomplished by the indoor unit, if the
indoor unit has no this feature, there is no
corresponding operation happened when
press the relative button on the remote
controller.
Please do not select HEAT mode if the
machine you purchased is cooling only
type. Heat mode is not supported by the
coolingonly appliance.
8 LOCK Button
Press this recessed button to lock all current
settings, and the remote controller will not
accept any operation except that of the LOCK.
Use the LOCK mode when you want to prevent
settings from being changed accidentally.
Press the LOCK button again to cancel the
LOCK function. A lock symbol will appear on
the remote controller display when the lock
function is activated.
7 RESET Button
Once the recessed RESET button is pressed,
all of the current settings will be cancelled
and the controller will return to the initial settings.
3
MODE FAN SPEED
SWING V SLEEP TIMER ON
TIMER OFF
CLOCK
RESET LOCK
M
AUTO
COOL
DRY
HEAT
FAN
4
5
7
8
9
10
11
12
13
14
15
2
1
TURBO
LED
SWING H
16
3
MODE FAN SPEED
SWING V SLEEP TIMER ON
TIMER OFF
CLOCK
RESET LOCK
M
AUTO
COOL
DRY
HEAT
FAN
4
5
7
8
9
10
11
12
13
14
15
2
1
TURBO
LED
SWING H
16
SELF CLEAN
6
I FEEL
SELF CLEAN
6
I FEEL
14
When the I FEEL function is activated, the
remote display is actual temperature at its
location. The remote control will send this
signal to the heat pump every 3 minutes
interval until press the I FEEL button again.
This indicator light remains on.
The I FEEL function is not available under
DRY and FAN mode.
Switch the operation mode or turn off the unit
will cancel the I FEEL function automatically.
Under SELF CLEAN mode, the heat pump
will automatically clean and dry the Evaporator
and keep it as fresh for the next operation.