Pridiom WIRE CONTROLLER OF AIR CONDITIONER KJR-12B/DP(T)-F User Manual - Manual (Page 10)

① Mode botton:
When press this botton,the operation
mode change as the following
sequence:
Remark: For the cooling only model, the
heating mode is skipped.
②
Timer on button :
Press this button, timer on function is
active. Then every press, the time
increase 0.5h, after 10h, 1h
increasement after each press. If cancel
this Function,just set it to "0.0" .
③
Timer off button:
Press this button, timer off function is
active.Then every press, the time
increase 0.5h, after 10h, 1h
increasement after each press. If
cancel this function, just set it to "0.0" .
④
Follow me button:
When under cool, heat and auto mode,
press this button, follow me function is
active. Press again, this function is
ineffective.
⑤ Electrical heater button :
If press this button in heat mode, electri-
cal heater function become ineffective.
⑥
Reset button(hidden):
Use a 1mm stick to press in the little hole ,
then the current setting is canceled . The
wire controller enter into original state.
⑦
ON/OFF button:
When in off state, press this button, the
indicator is on, the wire controller enter
into on state, and send setting information
to in door Pcb. When in on state,press this
button, the indicator is off, and send
instruction. If timer on or timer off has
been set, it concel this setting then send
instruction to stop the machine.
⑧
Adjust button ▲:
Set indoor temperature up. If press and
hold on, it will increase at 1°C(2°F) per
0.5 second.
⑨
Adjust button ▼ :
Set indoor temperature down . if press
and hold on,it will decrease at 1°C(2°F)
per 0.5 second.
6
→AUTO → COOL→DRY→HEAT→FAN