QOMO QRF300 Quick Start - Manual

Introduction to the QRF300 Audience Response System:
1. Remote and Dongle
Load two “AAA” batteries into the Student (F1-
1a) and Instructor (F1-1b) remotes.
2. Start the Software
a. Install QClick software from the CD.
b. Double-click the icon on the desktop to
launch QClick software.
c. Plug in the USB dongle (F1-1c), which should
be automatically recognized by QClick and go
into the login dialog.
d. Enter the default username and password, both
are “qomo”.
Note: If you click Cancel, QClick software will be
in Read-only Mode.
e. The QClick toolbar will appear and
shows“QRF300 Connected.” If the toolbar
shows “QRF300 No Host,” try to re-plug in the
USB dongle.
3. Set up a Class
a. Click the Class icon (F3.1-3a) under the Quiz
Genius tab. Click the Edit button (F3.2-3c)
next to the Class Name field. Select the Add
option and enter your class name. Click the
Add button (F3.2-3d) and the Student Settings
window pop up.
b. In the prompt Student Settings window select
‘Add New Students’. Enter Student ID, Name,
and Device No. found on the back of the
remote and any additional information in
Student Profiles window. Click Save to add a
student into the database. Click Close to
complete the settings.
c. Click OK button in Class Settings window.
Class icon (F3.1-3a) will turn to green when the
class is loaded.
Note: If the icon is not green, it means the class is
not loaded properly.