0 installation, 1 installing the devicenet interface, Installation – Rice Lake 880 Performance Series Panel Mount Indicator/Controller - DeviceNet Interface Option Installation and Programming Manual User Manual

Page 6

Advertising
background image

2

DeviceNet Installation and Programming Manual

2.0

Installation

This section describes the procedures used to install the DeviceNet Interface into the
an indicator.

2.1

Installing the DeviceNet Interface

Figure 2-1. DeviceNet Interface Kit

Disconnect power before removing indicator backplate.

Use a wrist strap to ground yourself and protect components
from electrostatic discharge (ESD) when working inside the
indicator enclosure.

1.

Disconnect indicator from power source.

2.

Unplug all connectors from the back of the controller assembly.

PN 156669 Backplate, Controller

PN 152360 Module, DeviceNet

PN 153093 Option Card

Also included in kit:
PN 14825 Screw, Mach 4-40NC x 1/4" Qty 4

J1

J2

J4

WARNING

CAUTION

Advertising