Rice Lake 880 Performance Series Panel Mount Indicator/Controller - Relay Card Option Installation Manual - Manual (Page 4)

J1
J2
J3
Connector J1
Pin Signal
1 K1 Common
2 K1 Normally Open
3 K2 Common
4 K2 Normally Open
5 K3 Common
6 K3 Normally Open
7 K4 Common
8 K4 Normally Open
Table 1. Relay Card
Pin Assignments
Figure 2. Relay Card Installation
15. Connect to the relay card as shown in Table 1.
16. Reassembly control box to the DIN rail.
17. Reconnect all connectors to the back of the controller assembly.
18. Reconnect power to the indicator.
Note
The indicator automatically recognizes all installed option cards when the unit is powered on. No
hardware-specific configuration is required to identify the newly-installed card to the system. However, Slot 1
must be configured for the desired output in the batch menu. See the Technical/Service Manual (PN 158387).
Specifications
4 SPST Normally Open Dry Contact Relays
250 VAC @ 3A
30 VDC @ 3A
Relay Protection The use of external fusing to limit current is recommended. Relay COM-NO are transient

protected to 400V @ 600W
Relay Contacts Displayed as Slot 1, Bit 1-4 in the setpoint configuration menu.
230 W. Coleman St. t Rice Lake, WI 54868 t USA
U.S. 800-472-6703 t Canada/Mexico 800-321-6703 t International 715-234-9171 t Europe +31 (0) 88 2349171
www.ricelake.com www.ricelake.mx www.ricelake.eu www.ricelake.co.in m.ricelake.com
© Rice Lake Weighing Systems 11/2013 PN 153859
Rice Lake Weighing Systems is an ISO 9001 registered company.