Rice Lake CLS-920i Cargo Lift Scale Daily Operator Card - Manual (Page 2)

2 CLS-920i Daily Operation Card
Toggle Units
Press the
UNITS
key to switch between primary,
secondary, and tertiary units.
Zero Scale
1. In gross mode, remove all weight from the scale
and wait for the standstill annunciator ( ).
2. Press the
ZERO
key. The center of zero ( )
annunciator lights to indicate the scale is zeroed.
Acquire Tare
1. Place container on scale and wait for the
standstill annunciator ( ).
2. Press the
TARE
key to acquire the tare weight of
the container.
3. Display shifts to net weight and shows the word
Net
on the display.
Remove Stored Tare Value
1. Remove all weight from the scale and wait for the
standstill annunciator ( ).
2. Press the
TARE
key (or, in OIML mode, the
ZERO
key). Display shifts to gross weight and shows
the word
Gross
.
Print Ticket
1. Wait for the standstill annunciator ( ).
2. Press the
PRINT
key to send data to the serial port.
To print tickets using auxiliary formats, press the
number key for the format, then press
PRINT
. For
example, to print using AUXFMT2, press
2
, then
PRINT
.
Accumulator Functions
The accumulator must be enabled before use in either
normal mode or setpoint operations. Once enabled,
weight (net weight if a tare is in the system) is
accumulated whenever a print operation is performed
using the
PRINT
key, digital input, or serial command.
The scale must return to zero (net zero if a tare is in the
system) before the next accumulation.
The
Display Accum
softkey can be configured to display
the current accumulator value. Printing while the
accumulator is displayed, or when the setpoint
PSHACCUM function is active, uses the ACCFMT
print format.
Press the
CLEAR
key twice to clear the accumulator.
Softkey Operations
Softkeys can be defined to provide operator additional
functions for specific applications. Softkey assignments
are listed on the tabs shown at the bottom of the LCD
display; softkey functions are activated by pressing the
arrow keys below the softkey tabs.
The particular set of softkeys shown on the display is
determined by the indicator configuration and program.
Softkey Description
Time/Date Displays current time and date; allows
time and date change.
Display Tare Displays tare value for the current scale
Display Accum Displays accumulator value, if enabled, for
the current scale.
Display ROC Displays rate-of-change value, if enabled,
for the current scale.
Setpoint Displays a menu of configured setpoints;
allows display and change of some
setpoint parameters.
Batch Start Starts a configured batch.
Batch Stop Stops a running batch and turns off all
associated digital outputs.
Batch Pause Pauses a running batch. (Same as stop,
but digital outputs, if on, are not turned
off.)
Batch Reset Stops a batch and resets it to the first
batch step.
Weigh In Allows truck ID entry; generates weigh-in
ticket for truck weighing applications.
Weigh Out Allows truck ID entry; generates weigh-out
ticket for truck weighing applications.
Truck Regs Displays truck register; allows deletion of
individual or all entries. Truck register can
be printed by pressing the PRINT key
while the truck register is displayed.
Unit ID Allows display or change of Unit ID.
Select Scale For multi-scale applications, provides a
prompt to enter the scale number to be
displayed.
Diagnostics Provides access to diagnostic displays for
attached
iQUBE junction boxes.
F1–F10 User-programmable keys; defined by
application.
More… For applications with more than five
defined softkeys, the More… key is
automatically assigned to the fifth softkey
position. Press More… to toggle between
groups of softkeys.
Table 1. Configurable Softkeys