Rice Lake Counting Scales - IQ6500 Operator Card - Manual

12/95
Determining a Unit Weight
1. From the net weighing mode, put a sample number of
pieces, 10 or more, on platform.
2. If you used a sample of 10, press PIECES (this key
defaults to 10). If you used a sample number other than
10, key in number of sample pieces with numeric keys
and then press PIECES. The unit weight per 1000
pieces is displayed on Unit Weight display.
Entering a Known Unit Weight
A known unit weight can be entered directly through the
keypad using numeric and decimal keys, and then com-
pleted by pressing UNIT WEIGHT.
One-Touch Tare
1. Place empty container on scale and press TARE once.
The Weight display shows zero with empty container
on scale.
2. Reset tare to zero by removing container and pressing
TARE or by pressing 0 and then TARE.
3. Press REZERO to rezero scale.
IQ6200/6500 Operator’s Card
Digital Tare Entry
1. Press REZERO. After resetting, all displays show
zero.
2. Enter the tare value using keyboard. Then press TARE.
For digital tare entry, decimal must be in appropriate
place as they would be displayed in Weight display. For
example, 250 would be entered as “0.250”, not “.250”.
3. The Weight display shows weight entered with a nega-
tive sign indicating that it is a tare weight.
4. The tare may be reset to zero by pressing 0 and then
TARE.
5. Press REZERO to rezero the scale.
Parts Counting
On the Scale Platform
After the unit weight is determined, additional parts may be
placed onto the platform and the correct weight and quantity
will be displayed. The original sample may be left on the
scale and the displayed weight and quantity will be the total.
Into a Container
After the unit weight is determined, place the empty con-
tainer onto the platform. Press TARE to tare off the weight
of the container.
As parts are added into the container, the Quantity display
shows the count.
Negative Parts Counting
This feature counts the parts quantity as you remove them
from a bulk container on the platform. (See Spec 08 in the
manual.) To perform negative parts counting:
1. Place the container (with parts) on platform
2. Press REZERO.
3. Take a 10-piece sample from container and press
PIECES (or key in number if other than 10 and press
PIECES). The Quantity display shows a count of 10
(or quantity entered).
4. Remove parts from container and watch Quantity dis-
play count up from number entered in step 3.
Accumulation
To accumulate a parts count from a series of weighments:
1. After a count has been developed, press + to store
displayed quantity in memory. The Quantity display
shows totAL, Memory lamp is lit, and memory subtotal
is displayed in upper display. Scale then returns to
weighing mode.
2. Repeat procedure for each container or quantity.
To clear memory after a series of accumulation entries,
press * after last +. This cancels stored memory (memory
lamp goes out).
If an entry must be deleted from accumulated total, place
correct quantity on scale or key in quantity to be subtracted,
and press -.
Note:
The IQ6200/6500 counting scale accumulates up to 999,999.