Power source coming from an external power supply, Go-between troubleshooting – Rice Lake Go-Between, Data Capture and Storage User Manual
Page 3
Go-Between Installation and Operation
3
Power Source Coming From an External Power Supply
For devices that are powered by an external power source use Table 2 and Figures 2 and 3 (below).
Table 2. Go-Between Serial Wiring with Power Coming From an External Power Source
Serial Output From Source Coming from
External Power Source
Go Between Input
GND
GND
TXD
RXD
Figure 2. Go-Between Serial Wiring with Power Coming From an External Power Supply and Connected Directly
Figure 3. Powered by External Power Supply and Connected via Power Supply Connector
Note
Both the power and serial connections must be grounded.
Go-Between Troubleshooting
If not able to save onto a USB stick, use the following steps.
1. Remove the USB stick.
2. Turn off power to Go-Between.
3. Turn power back on.
4. Move the reset switch to off (away from the USB stick).
5. Move back to on position.
6. Plug the USB stick in.